Milltronics PL-551 Technical Information PDF herunterladen (Seite 33)

100

101

SECTION TWO - FRONT PANEL OPERATION

Procedure for Setting a Work Offset

A work offset shifts the X and Y axis zero positions to a desired place (edge of the part). Thus a

part can be programmed from its part zero. To find and set a work offset, refer to the example.

Using a ½" diameter edge finder in the X axis, handwheel or jog to the edge of the part and

depress F8 (G54-X). Establish whether the edge finder is positive or negative from the desired

zero. Enter -.25 for the X position. The current position will read X -.25. Repeat this procedure

for the Y axis.

To check a work offset zero, select F5 (MDI), type G0 (rapid move) X0 Y0 (X and Y position to

0). Press Enter, then Cycle Start. Machine will position to the current work offset.

Caution: Machine will move in rapid mode. The tool should be above all parts, vises,

etc.

For more information on floating zero, see page 294, Section 4.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 440 441

Kommentare zu diesen Handbüchern

Keine Kommentare

Milltronics PL-551 Technical Information Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Milltronics PL-551